At first they asked implementing some sort of function with hardware. After that do it with less hardware. After that design on board a state machine recognising some specific series of 0s and 1s. Finally implementing multiplication of 8 bit numbers with 4 bit multipliers + whatever I needed. Also they asked about read after write problems to processors and things on computer architecture. Also they asked me things on my Thesis.
Question 2: what is the function of this circuit?
Technical questions regarding design aspects
A block diagram was given at the end with CAN Bus and a bunch of other blocks. How would you test this system?
What physiological things can affect a PPG measurement.
First question was to explain Ohm's law
Mosfet , bjt , full duplex , half duplex , communication protocols, zender diodes basic electronics questions
What FPGA's have you worked with and on what projects?
What are the layers of TCP/IP and OSI model
I was asked about what are the features available on an oscilloscope and multimeter and remember how many buttons are there on an average unit and what they did. When I mentioned that i am familiar with power electronics such as buck or boost converters, I was asked to draw a circuit of these converters.
Viewing 1 - 10 interview questions